Next:
User manual
Up:
HERMES HF Telecommunications Manual
Previous:
HERMES HF Telecommunications Manual
Contents
User manual
Introduction
HERMES HF Transceiver
HF Antenna Recommendation
Power Requirements
Web Interface
Administrative Interface
Transmission List
Public Messages (BBS)
Languages supported
E-mail
DeltaChat
Other email clients
Troubleshooting
Appendix - technical information
Network Information
Network Services
Other network Services
Additional information
Password Cheat Sheet
Field trials
Source Code
Licensing
GNU General Public License Version 3
sBitx installation guide
Introduction
Power supply and consumption
Initial setup to allow boot from USB pendrive
HERMES USB installer preparation
HERMES installation
WiFi Setup
Radio Frequency (RF) connections assembly
RF test
E-mail setup and test
Further troubleshooting (maintainers)
Software description (architecture and stack)
Introduction
HERMES Description
HERMES System Architecture
Topology and station roles
Reference architecture (v2 / sBitx + VARA-compatible TNC + UUCP)
Station component diagram
Service orchestration (systemd)
Interfaces: ports, paths and IPC
Dynamic behavior (message and call flows)
Variants
Architecture reference sources
HERMES Software Stack
ALSA (Audio configuration)
Radio control: trx_v2-userland (sbitx_controller)
Modem configuration
UUCP (Network configuration)
UUCPD: uucpd + uuport (UUCP to modem bridge)
User Web Interface
Hardware description
HERMES Hardware
HF Radio Transceiver
Antenna
Mini-computer
Power source
Essential tools
sBitx notes
Introduction
sBitx Hardware
Power consumption
Hardware interfaces to the computer (RPi 4)
Control I/O
Signal I/O
Linux setup for sBitx operation
Pin attribution setup for the RPi 4
Audio - ALSA subsystem
Ashhar's sbitx reference implementation
bridge setup
I2C bit-banging
RTC setup